It was a new bright pink lacy thong. I had never ordered them but checking the box I saw that it was sent to me. I got into the bathroom, dropped my t...ousers and boxers and slipped them on. I imediately got hard and found I couldnt pee, I didnt have time to finish myself off so I slipped on my trousers and with my hard on throbbing in my new panties put my socks and shoes on and went out. By the time I reached the bus stop I had shrunk to a manageable size but realised I still needed a pee. I. Her ass was thoroughly bruised and mottled, its smooth curves marred by violet welts. Even attempting to sit on the ledge was impossible without tooth-grinding discomfort. Her breasts were close to the same color, nipples swollen to several times their usual size. Her sex was almost literally on fire, her entrance an angry red blossom amidst a field of darker purple, and her labia and clitoris a perilously swollen terrain.She closed her eyes again.I wonder if the damage might be permanent.. I simply cannot count the number of times I was fucked, the number of blow jobs I gave, or the number of orgasms that were forced upon me in the weeks following our decision to grant my husband's best friend full access to my pussy. I loved every minute of it! Yes, in the privacy of my home, everything seemed perfect. However, in public, especially in situations where we could possibly encounter friends or neighbors, we were forced to discipline ourselves and act very differently. This. The three concerns are material, surface finish, and cleaning ability. Most 3D prints are printed in ABS or PLA. ABS is a toxic plastic and should probably be avoided for sex toys. PLA is a biodegradable based on corn starch so unless you have a corn allergy then you are probably ok. 3D prints are printed in layers so they can have lots of unpleasant ridges. A nice light sanding can help this surface finish. Lastly, the 3D prints are somewhat porous so sealing the surface with a FDA.