She jerked him off for a minute before taking him back into her mouth and almost immediately felt him getting ready to cum. Val increased her suction ...ntil he blew off into the roof of her mouth. She started keening with satisfaction, sucked every drop he had to offer and swallowed, impressing the hell out of Joe who had never had a girl do that before.When he grew soft, she released him and sat up looking at him as if she wasn't sure what to do next. Joe pulled her to him and kissed her. Val. .." I hummed delightedly.Adrienne grinned devilishly at me and began pumping furiously. It became much more difficult to concentrate on her orgasms with the sensations her fingers were giving me. I found myself humping back at her, eager to drive her digits deeper down my dark tunnels. I jammed my face and tongue into her crotch, lapping from her anus up to her clit, over and over again, savoring the flavors each crevice offered. Adrienne gritted her teeth again and came. I drove my tongue into. I nodded my head yes as he eased his cock into my wet, waiting hole. Bearing all his weight on me, he began a slow, easy rhythm that made me wetter with each thrust.“MMMmm, Joe. Yes! Yes, that feels good!” I said as I tried to maneuver myself closer to his thrusting cock. He pushed his cock all the way in and back one last time before pulling out completely. His hard pole twitching with anticipation of spurting the hot liquid that I was not ready for.“Nuh uh. Just a little bit longer,. Regardless of your exact fetish, there are a three steps you follow each time you create your own 3D printed sex toy.Step 1: 3D ModelEvery 3D print starts with a 3D model. You can create your own 3D model if you have CAD software like AutoCAD or SolidWorks, surfacing software like Rhino, or prefer the mind numbing 3D programming of the free open source OpenSCAD. Regardless of what software you use to create the model, you are trying to get a .STL file. The .STL file is for stereo lithography.