To insure a proper fit around the drill bit I cut out a similiar piece of sheet with my Carl Klenk metal shears, placed the metal on top of the open j...ws of the vice and whacked the drill bit laid on top of iron. Continuing the hammering I closed the jaws of the vice and pinched the sheet around the drill bit. This left a tube with ears. I turned the thimble over and squeezed the ears into a neck and soldered the top of the neck shut.At the lathe I turned a steel model and put the model on the. He had always been a good boy but unfortunately due to me being a single mother he had never had any male role models. As he became a teenager I kept waiting for him to begin to show an interest in girls but he never seemed to care. As his teenage years progressed I started to think that perhaps he was gay. I started to convince myself that I would be ok with that if it was the case. I started to deliberately look through his stuff when he was not around and finally I came across something. I. "Laura sat back down beside Kelly to hold her hand. With her other hand she turned down the volume on the stereo and noted with irony that the CD had moved forward to "The Tide Is High."Todd could see this was important so he sat down facing the two girls. Kelly took a big gulp of water and started to talk with a trembling voice."Todd, you know I love you and I wouldn't do anything in the world to hurt you, but, I can't deny my feelings for Laura anymore." She started to cry."Hey now... there's. I went near her lips and started kissing like a mad dog. I bit her lips so hard that it started bleeding a little bit on the corner and after a long kiss.I pushed her back, licked her neck all over till her lower ear, bit it and said, “Don’t ever call me Kiddo”. She was happy and smiling even after I handled her so roughly.She said, “That’s all you got Shaan, you’ve only made me bleed on top what about m..” and she raised her skirt for me to clearly see her pussy.She said, “Come on, don’t act.