Step 3: Post ProcessIf the toy you are making is only for show then you might not need any post processing. Accessories like necklaces, bracelets, or...rings may be used right off the printer. If the sex toy is going inside the human body or exposed to bodily fluids then you have three concerns and all of them can be addressed by treating the surface. The three concerns are material, surface finish, and cleaning ability. Most 3D prints are printed in ABS or PLA. ABS is a toxic plastic and. "This looks like a combination of a good Samaritan act and self defense. I don't think there will be anything further Mr. Phillips. You acted in good faith and were shot at. Around here, we don't cotton to wife beating. If it hadn't been you, someone else would have taken care of him, sooner or later."The Marshal excused himself and returned to his office to write up his report. The Phillips' women took the scared young lady down to their suite. Waite followed after closing the door. He caught. She squirmed, thrusted and whined aloud as she succumbed to the dream, each moment bringing her closer to the ultimate pleasure she could no longer deny.“YES! TAKE ME!” she screamed when the wave broke over her and she experienced her first organ in over three years as in her mind the young man ravaged her again and again.Four orgasms later Gwen finally regained control and, ashamed of herself, got up from the bed, straightened her clothing and, puzzled at this sudden onslaught of eroticism,. I finished cleaning the living room and wasnt sure what to do for the rest of the day now. My mom wouldnt be home until late tonight and I will already be asleep. I came up with the idea to just clean the dining room as well and even clean my bedroom which was a mess. I put everything away as to where it should be and finally called it quits. I was still a little bummed out that she had to go to work leaving me to wait until morning. But I guess it is what it is. It was going on eight pm so I.