Michael groaned when I touched his six-inch erection, and increased his volume when I slowly inserted his hard dick into my mouth. He tried to pull of... my shirt, but I stopped him and said, "I stay on one condition." Michael raised his eyebrows. "I'm in control the whole time." I pushed him onto the bed and resumed sucking on his beautiful cock. I moaned to show him he wasn't the only one being pleasured. As I sucked, I used my hands to play with his balls, which tightened; I knew he was. There was no message on his answering machine either at home or when he called to check at his office.He called the Twisp City marshall who radioed the resident County Sheriff’s deputy. Both men responded. Other than signs of the kitchen struggle and a small blood smear on the front gate post, there were no clues, no evidence left by the abductors. A close examination showed the door knobs, the gate latch, the screen door pull, all had been wiped clean. The gravel verge beside the paved lane. She slipped her finger into the fly and pulled it down. Within seconds she had my cock free from my jeans and was working it back and forth in her hand. Her firm grip felt so good and I knew I was going to cum shortly. I finished my work and slipped back out. As I stood up as slipped to her knees and toke the head of my cock into her tight warm mouth. With a gentle suck she worked my cock back and forth. Before long she had my entire rod in her mouth and down her throat. I was holding the back. Texas Steel had the latest fabrication equipment, but it still took a day of CAD programming to get it set up to form the roll above the windows.Andy’s design called for plate from the floor past the ceiling curve. That curve had to be done by a roll forming machine. The plates were four foot by eight foot and a half inch thick - they were heavy. The lower plates were easy, with the holes to bolt it through the wall pre-cut with a plasma cutter. It was the upper plate that was two and a half.